Filter
Top Products
-17-
W1751 25" Wide-Belt Sander
OPERATIONS
OPERATIONS
Figure 12. Control panel interface.
Control Panel
Below is a summary of your sander control panel and
the components that it controls. Use the list with
Figure 12 to become familiar with your sander.
• Sanding Load Amp Meter:
Indicates the amp load on the sanding motor when
a sanding operation is in progress. Never operate
the sander in the red zone.
• Sanding Belt Start and Stop Buttons:
Turns the sanding motor ON and OFF if the sander
has air pressure and the belt is tensioned.
• Power Lamp: Indicates when machine has
power to the control panel.
• Conveyor Belt Start and Stop Buttons:
Cycles the conveyor motor ON and OFF for
feeding wood into the sander.
• Emergency Stop Button: Stops all electrical
power to motors in event of emergency,
and stops sanding drums with an air-disc
brake. If button was pushed, you must
rotate the button so it pops back out, and
then you can start the machine again.
Sanding
Belt Stop
Button
Conveyor Belt
Stop
Button
Power
Lamp
Sanding
Belt
Start
Button
Conveyor Belt
Start
Button
Sanding
Load
Amp
Meter
Emergency
Stop
Button