Filter
Top Products
-18-
W1751 25" Wide-Belt Sander
OPERATIONS
General Operation
Test Run
Once assembly is complete, the machine is ready for
a test run. The purpose of a test run is to identify any
unusual noises and vibrations, as well as to confirm that
the machine emergency stop system is performing as
intended.
To complete the test run, do these steps:
1. Tie back loose clothing and hair, and make sure all
access doors and handles are secured.
2. Turn the sander and conveyor belt ON.
3. Using the start and stop buttons on the control
panel, cycle through sanding and conveyor
functions.
4. Listen for any unusual noises. A slow, rhythmic air
hiss is normal. The machine should run smoothly
with little or no vibrations.
—If there are any unusual noises or vibrations, shut
the machine
OFF immediately, and disconnect if
from power and air. Investigate the source of the
noise or vibration. DO NOT make any adjustments
to the machine while it is plugged in. Do not run
the sander until you fix the problem.
5. Push the emergency stop panel to test the
emergency stop system, and the sander should stop
almost immediately
.
Your sander will perform many types of operations that
are beyond the scope of this manual. If performed incor
-
rectly, sanding operations can be dangerous or deadly.
The instructions in this section are written with the
understanding that the operator has the necessary knowl
-
edge and skills to operate this machine. If at any time
you are experiencing difficulties performing any oper
-
ation, or you are inexperienced with this machine,
stop using the machine and consult your supervisor for
help!
If you are an inexperienced operator, we strongly rec
-
ommend that you read books, trade articles, or seek
training from an experienced wide belt sander operator
before performing any unfamiliar operations. Above all,
your safety should come first!
REMEMBER, this machine produces
fine sawdust particles that can be
inhaled, causing allergic reactions or
respiratory problems. ALWAYS wear
your respirator regardless if you use a
dust collection system. Dust collectors
do not adequately protect your lungs.
If you must use the emergency stop
panel to stop the sander, you may hear
the belts squeal, and smell a burnt
rubber odor coming from the right side
of the sander. The noise and smell
is a normal result because the brake
aggressively stops the sander. Only use
the emergency push panel to stop the
sander in an emergency situation. Do
not use it for normal shutdown. If you
do, you will wear out the belts, brake
pads, caliper, and rotor very quickly.
NOTICE