Filter
Top Products
-22-
W1755 6" Parallelogram Jointer
OPERATIONS
Squaring Stock
Squaring stock involves four steps performed in the order
below:
1. Surface Plane on the Jointer: The concave face of
the workpiece is surface planed flat with the jointer
(Figure 32).
2. Surface Plane on a Thickness Planer: The opposite
face of the workpiece is surface planed flat with a
thickness planer
(Figure 33).
3. Edge Joint on the Jointer: The concave edge of the
workpiece is jointed flat with the jointer
(Figure
34).
4. Rip Cut on a Table Saw: The jointed edge of the
workpiece is placed against a table saw fence and
the opposite edge cut off
(Figure 35).
Figure 32. Surface plane on the jointer.
Figure 34. Edge joint on the jointer.
Figure 33. Surface plane on a thickness
planer.
This Side Previously
Surface Planed
Figure 35. Rip cut on a table saw.
This Side
Previously Edge
Jointed