Filter
Top Products
-34-
W1755 6" Parallelogram Jointer
SERVICE
To adjust the table parallelism, do these steps:
1. DISCONNECT JOINTER FROM POWER SOURCE!
2. Remove the cutterhead guard and fence.
3. Place the straightedge on the outfeed table so it
hangs over the cutterhead, and lower the outfeed
table until the straightedge just touches the
cutterhead body, as shown in
Figure 51.
4. Remove the top set screw from each of the four
eccentric bushings (
Figure 55), then loosen the set
screws underneath those removed set screws (there
are two stacked set screws in each location).
5. Place the straightedge in one of the positions shown
in Figure 52, and adjust the table (a small ham-
mer and punch or pin-type spanner wrench may be
necessary to turn the eccentric bushings) so that the
straightedge touches the cutterhead body while lying
flat across the outfeed table. Repeat this step with
each of the remaining straightedge positions as many
times as necessary until the outfeed table is parallel
with the cutterhead body.
6. Tighten/replace the set screws in the eccentric
bushings on the outfeed table.
7. Remove the set screw from each of the four eccen-
tric bushings for the infeed table, then loosen the
set screws underneath those removed set screws.
8. Place the straightedge halfway across both the
infeed and outfeed tables, then adjust the infeed
table even with the outfeed table (
Figure 53).
9. Place the straightedge in one of the positions shown
in Figure 54, and adjust the eccentric bushings
under the infeed table so the straightedge lies flat
against both tables. Repeat this step with each of
the remaining straightedge positions as many times
as necessary until the infeed table is parallel with
the outfeed table.
10. Tighten/replace the set screws in the eccentric
bushings on the infeed table.
11. Set the outfeed table height (refer to Page 35).
12. Set the knives (refer to Page 29).
13. Reinstall the cutterhead guard and fence.
Figure 55. Eccentric bushing and set screw
location.
Eccentric
Bushing
Location of
Stacked Set
Screws