Filter
Top Products
Model W1783 (Mfg. Since 2/07)
-8-
NOTICE
If you are using pre-finished
flooring material, test the nailer on a
sample strip. If the nailer base plate
is damaging or marring the flooring
surface, replace it with a new one.
Place the nailer on the flooring strip,
as shown in .
Make sure the cleat on the nailer
base plate is lined up with the edge
of the groove on the flooring strip.
Using the rubber end of the included
hammer, hit the whack cap of the
nailer ONCE with a light to medium
force to shoot a nail into the wood.
Check the nail for satisfactory
penetration.
— If the nail depth is satisfactory,
proceed with your project.
— If the nail depth is too shallow,
slightly increase the air pressure.
— If the nail depth is too deep,
slightly decrease the air pressure.
Nailing penetration is not
always consistent due to variations in
the flooring material. If necessary,
use a hammer and nail punch to
finish seating the nail.
A jammed nail must be cleared before
using the nailer again.
DISCONNECT NAILER FROM THE AIR
SUPPLY!
Pull the magazine pusher all the way
back and remove the nail stick.
Positioning nailer on flooring
strip and operating.