Filter
Top Products
Model W1783 (Mfg. Since 2/07)
-11-
Use a good solvent to clean the nose
assembly of the nailer. Always be sure
that the nailer is dry before using it
again.
Do not allow dust, chips, sand, etc.
into the air connectors or into the body
of the nailer; this may result in leaks
and damage to the nailer and the air
couplings.
Place two to six drops of pneumatic tool
oil in the nailer air inlet (as shown in
Figure ) every 2 hours of continuous
use. Wipe off any excess oil near the
nailer exhaust to avoid dust build-up.
Another option to manual oiling would be
to simply install a lubricator in your air
compressor line. If your air compressor
line already has a lubricator, then regular
lubrication of your nailer will not be
necessary. Just make sure there is always
oil in the lubricator.
Lubricating nailer via air inlet.