Filter
Top Products
Model W1783 (Mfg. Since 2/07)
-7-
When replacing nails in your Model
W1783, follow these guidelines:
Nails .................... L-Shaped Cleat Nails
Length: ....................................1"–2"
Capacity: ................................... 100
Use 1
1
⁄2" nails to install
1
⁄2" flooring,
and 2" nails to install
3
⁄4" flooring.
DISCONNECT NAILER FROM THE AIR
SUPPLY!
Slide a strip of nails, pointed-end
down, into the rear of the magazine,
as shown in .
Press the button inside the pusher
(see inset photo, ), pull the
pusher all the way back, then allow
the pusher to slide forward against
the nail strip.
If you have not read the safety
instructions in this manual, do not
operate the nailer.
Before you operate your nailer, place five
to six drops of the included oil into the
quick connect fitting where the nailer
connects to the air supply.
The Model W1783 comes with two base
plates:
— The thinner base plate is for use
with
3
⁄4" flooring.
— The thicker base plate is for use
1
⁄2" flooring.
Install the correct base plate for your
size of flooring material.
Place the flooring nailer on the floor
with the nail discharge facing down,
then connect the air supply.
Loading nails into the nailer.
Position a flooring strip and tap it
into place with the metal side of the
included hammer.