Filter
Top Products
Model W1783 (Mfg. Since 2/07)
-9-
The jammed nail should be visible in
the discharge area.
— If the jammed nail can be removed
with needle nose pliers, do so and
continue to .
— If you cannot remove the jammed
nail, then continue with
Use the 4mm hex wrench and remove
the four cap screws and lock washers
that secure the magazine to the
nailer (see ).
It may be necessary to remove
the base plate to pull the magazine
out.
Throw the damaged nail away and
insert a new nail stick that only
contains clean, undamaged nails. DO
NOT use dirty or damaged nails!
Under heavy use, the piston or O-rings
may wear out. Replacement is quick and
easy. Contact your authorized Shop Fox
dealer to obtain the Piston Repair Kit
(Part Number X1783068) or Complete O-
Ring Kit (Part Number X1783070).
DISCONNECT NAILER FROM THE AIR
SUPPLY!
Remove all the nails from the
magazine.
Use the 4mm hex wrench and remove
the four cap screws and lock washers
that secure the magazine to the
nailer (see ).
It may be necessary to remove
the base plate to pull the magazine
out.
Location of cap screws securing
the magazine to the nailer.
Remove the jammed nail from inside
the discharge area with a pair of
need nose pliers (see ).
Jammed nail in discharge area.
Re-install the magazine.