Woodstock W1783 Nail Gun User Manual


 
Model W1783 (Mfg. Since 2/07)
-10-
 Use a 5mm hex wrench to remove the
four cap screws that secure the base
to the nailer body (see ).
 Cap screws that secure the
base to the nailer body.
 Carefully slide the base from the
nailer body, and remove the large
base washer and rubber bumper (see
).
 Washer and rubber bumper.
Washer
Bumper
 Use a flat head screwdriver to pry off
the whack cap (see ).
 Whack cap and cylinder cover.
Whack Cap
Cylinder
Cover
Exhaust
Port
 Remove the four cap screws and lock
washers from the cylinder cover, and
remove it from the nailer body.
 Remove the three cap screws from
the top of the plunger (see ).
 Plunger and cap screws.
Plunger
Cap Screw
 From the bottom of the nailer, pull
out the piston assembly.
 Push the piston into the sealing
sleeve and remove the sealing cap
from the top of the piston.
 Pull the piston from the sleeve (see
).
 Piston assembly.
Sealing Sleeve
Piston
 Apply a thin film of tool oil to the
new O-rings before installing them to
seat them properly on the parts.
 Reverse the steps above to
reassembly the nailer with the new
piston.