Filter
Top Products
-37-
N(/((('Jc`[`e^KXYc\JXn
FG<I8K@FEJ
JZfi`e^9cX[\@ejkXccXk`fe
8[aljkd\ek
The scoring blade included with the sliding table saw has
wedge shaped teeth. The kerf thickness is adjusted by
changing the height of the scoring blade.
To change the scoring blade, do these steps:
(% DISCONNECT SAW FROM POWER!
)% Move the blade tilt to 0˚ (blade 90˚ to table), and
raise the scoring blade all the way up.
*% Move the sliding table all the way forward and pull
the internal blade guard open. (The internal blade
guard is held in place with a magnet.)
+% Remove the upper blade guard.
,% To remove the scoring blade, insert the arbor lock
tool in the table (=`^li\,/), rotate the scoring
blade to seat the arbor lock tool, and use the arbor
wrenches to remove the arbor nut and arbor flange.
Efk\1K_\XiYfielk_Xji`^_k$_Xe[k_i\X[jXe[
cffj\ejYpklie`e^Zflek\iZcfZbn`j\%
-% Install the new scoring blade, re-install the arbor
flange and the arbor nut, and tighten them against
the blade set. There MUST be an arbor flange
between the blade and the arbor nut.
.% Unlock the scoring blade controls by inserting a 6mm hex wrench into the controls lock hole shown
in =`^li\,0 and turning the mechanism inside counterclockwise until loose.
/% Adjust the height of the scoring blade until the exposed portion equals the kerf thickness of the
main blade. The scoring blade height control is accessed through the hole in the table (=`^li\
,0)and adjusts with a 6mm hex wrench. Use a straightedge to verify that the scoring blade kerf
matches the main blade.
0% If the scoring blade is not aligned with the main blade, adjust the blade alignment control (=`^li\
,0), using a straightedge as a guide.
('% Tighten the controls lock.
((% Move the lower blade guard back into its original position, and center the sliding table.
()% Perform a test cut and check for chip out on the underside of the test piece. If there is chip out,
make the adjustments necessary to match the kerfs.
=`^li\,/%Removing the scoring blade.
Arbor Lock
Tool
=`^li\,0% Checking and adjusting scoring
blade positioning.
Controls Lock
Height Control
Alignment Control