Filter
Top Products
-38-
N(/((('Jc`[`e^KXYc\JXn
FG<I8K@FEJ
;X[f9cX[\@ejkXccXk`fe
This saw can only accept a dado blade with
5
⁄8" arbor
hole and a maximum diameter of 8". The maximum width
of dado blade that can be installed is
13
⁄16". Attempting
to install a dado blade that is sized larger than these
maximum sizes is dangerous and should be avoided. If you
have any doubts or questions about the size of dado blade
you want to install, call our Technical Support before
proceeding.
In order to install a dado blade, the scoring blade must
be removed and a zero-clearance table insert must be
made specifically for the dado blade you will install. If
you plan on making dadoes at varying widths, we strongly
recommend making a zero-clearance table insert for each
thickness of dado blade that will be used.
A zero clearance insert can be made for the saw in less
than 30 minutes, and can be made of
3
⁄4" furniture quality
plywood or a hardwood.
@k\djE\\[\[ Hkp
Table Saw ........................................................1
Drill Press ........................................................1
Sander ............................................................1
Drill Bits
7
⁄32" and
13
⁄32" ................................. 1 Each
Plywood/Hardwood Piece 14" x 1
1
⁄16" x
3
⁄4" ................1
KfdXb\Xq\ifZc\XiXeZ\kXYc\`ej\ik#[fk_\j\jk\gj1
(% DISCONNECT SAW FROM POWER
)% Lower the main blade all the way down, remove the
blade guard, riving knife, and scoring blade. After
removing the scoring blade, reinstall the scoring
blade flanges and scoring arbor nut and tighten it.
*% Remove the main blade and the mounting spacer
behind it (see =`^li\-').
+% Remove the table insert that came with the saw.
,% Cut the new table insert to the exact length of the
included table insert and 1
1
⁄16" wide.
-% Use the included table insert as a template, as
shown in =`^li\-(, to mark the mounting holes on
the new table insert. (Clamping the pieces together
while you do this will allow you to ensure the hole
spacing is exact.)
=`^li\-'% Existing insert removed.
=`^li\-(% Marking location for mounting
holes in new insert.