Filter
Top Products
-44-
N(/((('Jc`[`e^KXYc\JXn
FG<I8K@FEJ
D`k\i:lkk`e^
The crosscut fence allows miter cuts from 0˚ through 135˚.
The table mounted miter scale has a resolution of 1˚.
Kfg\i]fidXd`k\iZlk#[fk_\j\jk\gj1
(% Slide the crosscut table to the front edge of the slid-
ing table and lock it in place.
)% Place the crosscut fence center stud in the left or
right stud hole of the crosscut table. The fence can
be installed as shown in =`^li\..for 90˚ to 135˚
cuts, or as shown in =`^li\./for 0˚ to 90˚ cuts.
*% Rotate the fence to the desired angle and lock it in
place.
4. Position the flip stop according to the length of the
workpiece you want to cut off to the left of the
blade.
5. Load the workpiece onto the table saw. The setup
should look similar to Figure ./.
6. Once all the necessary safety precautions have been
taken, perform the cutting operation.
=`^li\..% Fence set-up for 90˚ to 135˚
cuts.
=`^li\./% Example of miter cutting
operation (0˚ to 90˚).