Filter
Top Products
-55-
N(/((('Jc`[`e^KXYc\JXn
J<IM@:<
JZfi`e^9\ckI\gcXZ\d\ek
(% DISCONNECT SAW FROM POWER!
)% Tilt the blade to 45˚ and lower it as far as it will go.
*% Remove the motor cabinet door.
+% Pull the tensioner away from the scoring belt (=`^li\
0,) to relieve belt tension and remove the scoring
belt from the pulleys.
Efk\1Kliek_\Y\ckj`[\nXpjkfjhl\\q\k_\]cXk
gXikk_ifl^_k_\jdXcc^XgY\kn\\ek_\Yfkkfdglc$
c\pXe[k_\ZXjk`e^%
,% Put the new scoring belt on the pulleys as shown in
=`^li\0-, and push the tensioner against the scor-
ing belt to take up any slack.
-% Replace the motor cabinet door.
9cX[\K`ck:Xc`YiXk`fe
The blade tilt is calibrated at the factory, but can be
recalibrated if it changes during the life of the machine.
The 0° stop positions the blade square with the table.
'Jkfg
(% DISCONNECT SAW FROM POWER!
)% Move the blade tilt to 0° according to the gauge,
and raise the main blade as far as it will go.
*% Use a machinist's square to check if the blade is
square to the table.
— If the blade is not square to the table, loosen the
two set screws that secure the 0˚ tilt stop nut
shown in =`^li\0.%
+% Adjust the stop nut and recheck the blade tilt as
many times as necessary until the blade is square to
the table.
,% Tighten the two set screws in the stop nut.
-% Check the blade tilt pointer mechanism to ensure
that it points to 0°.
— If the blade tilt pointer shows an incorrect tilt,
adjust it by loosening the cap screws, rotating the
pointer until it points to 0°, then tightening the
cap screws.
Scoring Belt
Tensionser
=`^li\0,% Replacing the scoring motor
belt (table removed for clarity).
Scoring Belt
IZch^dcZg
BdidgEjaaZn
2EjaaZn$GdaaZg
2HXdg^c\7Zai
=`^li\0-% Scoring belt installation
configuration.
=`^li\0.% Blade tilt stop nut (0°).
0° Tilt
Stop Nut