Filter
Top Products
-15-
Model W1821 (For Machines Mfg. Since 3/10)
OPERATIONS
Groove cutting produces a groove or bead into the face of
the board.
To cut a groove into the face of the workpiece, do
these steps:
1. DISCONNECT ROUTER FROM POWER!
2. Secure the bit into the router according to the
router manufacturer's instructions.
3. Install the smallest table insert into the table that
still allows the bit to freely rotate.
4. Make sure both fence boards are even with one
another and secured to the fence assembly.
5. Raise the bit to the desired height, then adjust the
fence assembly so that the fence boards are behind
the bit the same distance as the desired depth-of-
cut (see the illustrations in Figures 21–22).
6. Lock the fence assembly in place, tighten all knobs,
connect the router to power, then perform the cut.
Depth-of-Cut
Top View
Figure 21. Groove cutting setup—top view
(guard removed for clarity).
Depth-of-Cut
Side View
Fence
Bit
Table
Rub Collar
Figure 22. Groove cutting setup—side view
(guard removed for clarity).
Groove Cutting