Filter
Top Products
11
10
12
6
12
FIG. 18
FIG. 19
WORK
BOIS
MADERA
LOOKING DOWN ON SAW
VUE DE DESSUS
VISTA HACIA ABAJO SOBRE LA SIERRA
FIG. 15
FIG. 16
32.
Attaching Blade Guard
1. From among the loose parts, locate the following hardware
(Fig. 15).
ITEM DESCRIPTION QTY.
6 Blade Guard and Spreader 1
13 Spreader Support Assembly 1
14 Flat Washer 1
15 Lockwasher (1/4" External) 1
16 Hex Bolt (1/4-20 x 2") 1
Note: Adjustments to the following bolt & screws can be done
using the small end of arbor wrench (see page 24) or a 10 mm
wrench (see page 7).
2. Align flats on inside of speader support assembly 13 with flats
on end of pivot rod 7 located on back side of table 8 and fasten to
pivot rod 7 using the 1/4-20 x 2" long hex bolt 16, 1/4" external
tooth lockwasher 15 and flat washer 14 (Fig. 15).
3. Remove flanged hex bolt 21 and remove clamping plate 22.
(Fig. 16).
4. Position spreader 6 over bumps 9, then position clamping plate
22 over bumps 9 and securely tighten flanged hex bolt 21.
(Fig. 16).
IMPORTANT: The Spreader 6 must always be IN LINE with the
sawblade 10. The spreader 6 is thinner than the width of the KERF
11 by approximately three thicknesses of paper 18 on each side
of the spreader 6 (Fig. 19).
5. Loosen hex nut 20, then flanged hex bolts 23 with the 10 mm
open end wrench. Loosen set screw 19 with a flat tip screwdriver.
(Fig. 18).
6. Place rip fence 2 on table, lift up ANTIKICKBACK PAWL and
CAREFULLY move fence 2 against the blade so that it is parallel to
the blade, and just touches tips of saw teeth 10, and lock fence 2
in this position (Fig. 18).
7. Make two folds in a small piece (6" x 6") of ordinary newspaper
making three thicknesses (Fig. 17). The folded paper 18 will be
used as a “spacing gauge” (Fig. 18).
8. Insert folded paper 18 between SPREADER and FENCE. Hold
spreader firmly against fence (Fig. 18).
9. First lightly tighten the flanged hex bolts 23 and then the set
screw 19. Recheck squareness of spreader to table and
parallelism to blade. Readjust if necessary.
10. After proper alignment adjustment is made, tighten hex nut 20
and securely tighten flanged hex bolts 23.
NOTE: Always be sure the spreader stays in line with blade when
the blade is tilted at any angle.
Assembly
14
15
16
13
6
7
8
21
22
9
FIG. 17
18
20
19
23
23
2
6
18
10