Filter
Top Products
0
º
5
º
1
0
º
1
5
º
2
0
º
2
5
º
3
0
º
3
5
º
4
0
º
4
5
º
9
10
11
1
1
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
8
FIG. 1
FIG. 2
FIG. 3
58.
MODELS 3400-08 & 3400-12 ONLY
TOOLS REQUIRED (FIG. 1)
A 12mm Wrench or Adjustable End Wrench
BEFORE YOU ASSEMBLE THIS TOOL STAND
Sort out and account for all parts to make sure that you have all
necessary materials to assemble your tool stand. Do not discard
packing material until all parts are accounted for. Measure length
of rails to properly identify each piece (Fig. 2).
NOTE: PARTS A, B, C, D, E ARE IMPRINTED WITH THEIR
CORRESPONDING LETTER FOR EASY IDENTIFICATION
ITEM DESCRIPTION QTY.
1 Leg (A) 4
2 Front - Top Rail (20-1/4" Long) (B) 2
3 Front - Bottom Rail (24-1/4" Long) (C) 2
4 Side - Top Rail (17-3/4" Long) (D) 2
5 Side - Bottom Rail (21-3/4" Long) (E) 2
6 Carriage Bolt (5/16" - 18 x 5/8") 24
7 Hex Nut (5/16" - 18) 24
8 Leg Pad 4
PARTS FOR TABLE SAW MOUNTING
ITEM DESCRIPTION QTY.
9 Hex Bolt (5/16" - 18 x 1-3/4") 4
10 Flat Washer (5/16") 4
11 Hex Nut (5/16" - 18) 4
HELPFUL ASSEMBLY HINTS
Assemble nuts and screws finger tight only until completely
assembled as adjustments may be necessary.
After completing adjustments, securely tighten all
fasteners. An unstable stand may shift in use and
cause serious personal injury.
The stamped rails may have sharp edges. Be
careful in handling the rails to prevent being cut.
ASSEMBLY (FIG. 2)
1. Using two carriage bolts 6, and two nuts 7, assemble ends of
rail
2 to inside upper end of two legs 1 by inserting
bolts through leg first then through rail
2 and securing with
nuts
7.
Rails are always inside of legs and small rail flanges are always
up.
2. Using four carriage bolts
6, and four nuts 7, assemble ends of
rail
3, to inside lower end of same two legs.
3. Repeat steps 1 & 2 to make other subassembly.
4. Using two carriage bolts
6, and two nuts 7, assemble ends of
rail
4 to inside upper end of two legs 1 by inserting
bolts through leg first then through rail
4 and securing with
nuts
7.
5. Using four carriage bolts
6, and four nuts 7, assemble ends of
rail (
5), to inside lower end of same two legs.
6. Assemble one leg pad
8 to bottom of each leg 1.
MOUNTING TABLE SAW TO STAND
(FIG. 3)
1. Place tool on tool stand as shown.
2. Insert one hex bolt
9 through one flat washer 10, and then
through the hole in top side of tool base first, then through stand.
3. Secure with nut
11.
4. Repeat steps 2 & 3 on other legs.
5. Be sure that stand is level, and securely tighten all nuts.
WARNING
!
WARNING
!