Filter
Top Products
20
Operation
INITIAL PROGRAMMING OF CONSOLE COMPUTER
(CONTINUED)
ENTER MODE SEQUENCE WITH ACTIVATED DATA-LOCK
1. Depress the key into which you wish to enter data.
2. Depress
CODE message will appear. Enter your DATA-LOCK CODE. If code is correct, “E” will
appear. Now enter data normally.
The DATA-LOCK feature prohibits the entry of data without first entering the DATA-LOCK CODE. The DATA-
LOCK CODE may be cleared by entering a code of “0” or by removing Console power.
POWER DOWN DELAY TIME FEATURE
If the console is not used for 10 days, it will go into a power down (low power) mode of operation. In this mode,
all data will be retained, but the time of day clock will reset to 1:00. The delay time is initially set at 10 days, but
can be changed by the user.
1. DISPLAYING DELAY TIME. Depress
for 5 seconds, the current delay time (in days) will appear.
2. CHANGING DELAY TIME.
a. Depress FOR 5 seconds, the current delay time will appear.
b. Enter new delay time (0 to 200 days) using the same procedure as that for entering other data.
In the event of console power loss, the power down delay time will default to 10 days.
CONSOLE ALARM FEATURE
Console alarm sounds if application rate is 30% or more away from target application rate for 5 seconds.
ALARM MENU
Depress for 5 seconds until DATA display shows “A on”. Depressing momentarily key steps the
DATA display between “A on” and “AoFF”. “A on” means alarm is enabled, “AoFF” means alarm is disabled.
DISPLAY MENU
Depress for 7 seconds until DATA display shows "d on”. Depress momentarily key steps the DATA
display between “d on” and “doFF”. “d on” means RATE displays target rate when actual rate is within a per-
centage of target rate. This percentage is determined by third digit of Valve CAL value as shown.
Brake point digit
(3rd digit) of Valve CAL 2 1 2 3
0 = 1% + Deadband 4 = 20% + Deadband 8 = 40% + Deadband
1 = 3% + Deadband 5 = 25% + Deadband 9 = 45% + Deadband
2 = 7% + Deadband 6 = 30% + Deadband
3 = 10% + Deadband 7 = 35% + Deadband
Actual rate is displayed if unit does not reach deadband with in 10 seconds. “doFF” means RATE displays ac-
tual rate at all times.