Filter
Top Products
For Machines Mfg. Since 8/09 Model SB1018
-15-
PREPARATION
Assembly
To assemble the bandsaw:
1. Attach the left and rear panels and the
bottom shelf together as shown in Figure 9
with three M8-1.25 x 15 hex bolts, three M8-
1.25 hex nuts, and six 8mm flat washers.
Figure 9. Left and rear panel assembly.
Figure 10. Right panel assembly.
2. Attach the front panel in the same manner
as Step 1.
3. Attach the right panel to the stand assembly
as shown in Figure 10 with four M8-1.25
x 15 hex bolts, four M8-1.25 hex nuts, and
eight 8mm flat washers.
4. Install the shelf in the stand assembly as
shown in Figure 11 with (2) M8-1.25 x 15
hex bolts, (2) M8-1.25 x 15 flat head screws,
(4) M8-1.25 hex nuts, and (6) 8mm flat
washers.
5. Install the handle with four M8-1.25 x 40
hex bolts, eight 8mm flat washers and four
M8-1.25 hex nuts as shown in Figure 10.
6. Carefully place the stand assembly upside
down.
x4
Figure 12. Handle installation.
x4
Left Panel
Rear Panel
Right Side Panel
Bottom Shelf
Stand
Assembly
Figure 11. Shelf installation.
x2
x2
Top View
x3