Filter
Top Products
-16-
For Machines Mfg. Since 8/09
Model SB1018
PREPARATION
Figure 13. Wheel assembly.
Figure 15. Mounting bandsaw to stand.
7. Insert the axle through the holes in the base
assembly, then slide the wheels over the axle
and secure each with a cotter pin, as shown
in Figure 13.
8. Thread the leveling feet into the stand
assembly, as shown in Figure 14. You can
adjust these later as needed to level the
bandsaw.
9. With the help of another person, flip the
stand assembly right-side up, then place
the chip tray onto the stand, lining up the
mounting holes.
10. With the help of another person, lift the
bandsaw assembly and place it onto the
stand assembly, lining up the mounting
holes.
11. Secure the bandsaw to the stand with four
M12-1.75 x 25 hex bolts and 12mm flat
washers, as shown in Figure 15.
12. Loosen the belt tension bolt shown in Figure
16.
Figure 16. Belt tension bolt location.
Belt Tension Bolt
Axle
Wheel
Base
Cotter Pin
Figure 14. Leveling feet.
Leveling
Feet
(Handwheel Not Yet
Installed)
(Pulley Cover Not
Yet Installed)
Hex Bolts
(2 of 4 Shown)