Filter
Top Products
For Machines Mfg. Since 8/09 Model SB1018
-17-
PREPARATION
Figure 17. Installing belt.
Figure 19. Pulley cover knob.
13. Pivot the motor assembly upward, then place
the belt over the gearbox and motor pulleys,
as shown in Figure 17.
14. Install the pulley cover (Figure 18) with two
M6-1 x 12 hex bolts, three 6mm flat washers,
and the South Bend cast aluminum knob
(see Figure 19).
15. Slide the vise handwheel onto the leadscrew
and tighten the set screw shown in Figure
20. Thread the handle into the handwheel
and tighten it.
Motor Pulley
Gearbox
Pulley
Motor
Assembly
Knob Location
Figure 18. Pulley cover.
Hex Bolts
Belt
Cover
Figure 20. Vise handwheel.
Set Screw
Handwheel
Handle