Filter
Top Products
-16-
For Machines Mfg. Since 8/09
Model SB1020
PREPARATION
Machine Setup
To ensure that your bandsaw arrives without
damage to the hinge system, a shipping strap
was installed. After removing the shipping strap,
you may choose to install the work stop.
To set up the machine:
1. Remove the shipping strap hex bolt and
strap as shown in Figure 10. Keep this
shipping strap in case you transport or ship
the bandsaw in the future.
Figure 10. Removing a shipping strap.
2. Thread the work stop rod into the vise base.
3. Slide the work stop onto the work stop rod,
position it as necessary, then tighten the set
screw shown in Figure 11.
Set Screw
Figure 11. Installing work stop.
Power Connection
Electrocution or fire
may occur if machine is
ungrounded, incorrectly
connected to power, or
connected to an undersized
circuit. Use a qualified
electrician to ensure a safe
power connection.
Once your machine is set up and assembled as
previously described in this manual, it is ready to
be connected to the power source.
• Ifyouplantousethemachineat110V,
simply plug it into a receptacle on a 110V
circuit that meets the requirements listed on
Page 10.
• Ifyouplantousethemachineat220V,you
will have to convert the machine for 220V.
Refer to Electrical, beginning on Page 42.
Shipping Strap
Work Stop