Filter
Top Products
PREPARATION
-12-
For Machines Mfg. Since 8/09
Model SB1040/SB1041
PREPARATION
Preparation Overview Things You'll Need
During the setup process, operation, and
maintenance of your machine, you'll need the
following items:
For Lifting
s !FORKLIFTOROTHERPOWERLIFTINGDEVICE
rated for the weight of the machine.
s ,IFTING3TRAP or chain w/safety hook
(rated for at least 1000 lbs.)
For Power Connection
s !QUALIFIEDELECTRICIANTOENSUREASAFE
and code-compliant connection to the
power source. (Refer to Page 20 for
details.)
For Assembly
s Cotton Rags
s Mineral Spirits
s 3AFETY'LASSES
s Oil Can with any General Machine Oil
s Blade Tension Tool
s Grease Gun with any API GL 2 Grease
s Stiff Grease Brush
s Phillips Screwdriver #2
s &LOOR-OUNTING(ARDWARE!S.EEDED
s Hex Wrench 5mm
s Hex Wrench 6mm
s Combo Wrench
1
⁄2" or Ratchet and
1
⁄2"
Socket
The purpose of the preparation section is to help
you prepare your machine for operation. The list
below outlines the basic process. Specific steps
for each of these points will be covered in detail
later in this section.
The typical preparation process is as follows:
1. Unpack the machine and inventory the
contents of the box/crate.
2. Clean the machine and its components.
3. Identify an acceptable location for the
machine and move it to that location.
4. Level the machine and either bolt it to the
floor or place it on mounts.
5. Assemble the loose components and make
any necessary adjustments or inspections to
ensure the machine is ready for operation.
6. Connect the machine to the power source.
7. Test run the machine to make sure it
functions properly and is ready for operation.