Filter
Top Products
-38-
For Machines Mfg. Since 8/09
Model SB1040/SB1041
MAINTENANCE
If the table becomes difficult to tilt, position it so
that you can brush a thin coat of multi-purpose
grease on the trunnion sliding surfaces (see
Figure 42), then move the table back and forth
to distribute.
Lubrication
The bearings on your bandsaw are factory
lubricated and sealed. Leave them alone unless
they need to be replaced.
When needed, brush a light coat of multi-purpose
grease on the blade tension leadscrew (see
Figure 40).
Use multi-purpose grease and a light machine oil
where indicated in Figure 41.
Figure 41. System lubrication points.
Grease
Fitting
Oil
Grease
Grease
Fitting
Behind
Plate
Oil
!
Figure 40. Upper wheel leadscrew lubrication.
Grease
!
The sliding surfaces on the guide post may
occasionally need to be lubricated with a light
machine oil if the movement becomes stiff.
Figure 43. Guide post lubrication.
Oil
!
Figure 42. Trunnion lubrication.
Trunnion Sliding
Surfaces
!