Filter
Top Products
-18-
For Machines Mfg. Since 8/09
Model SB1040/SB1041
PREPARATION
Lifting & Moving
Make sure the lifting eye shown in Figure 7 is
completely threaded into the headstock, then lift
the machine off the pallet and onto a suitable
location using the lifting eye.
Figure 7. Lifting location.
This machine and its
parts are heavy! Serious
personal injury may occur
if safe moving methods are
not used. To reduce the
risk of a lifting or dropping
injury, ask others for help
and use power equipment.
Securing to Floor
We strongly recommend securing your
machine to the floor if it is hardwired to the
power source. Consult with your electrician to
ensure compliance with local codes.
Generally, you can either bolt your machine
to the floor or mount it on machine mounts.
A
lthough not required, we recommend that you
secure the machine to the floor and level it while
doing so. Because this is an optional step and
floor materials may vary, hardware for securing
the machine to the floor is not included.
Bolting to Concrete Floors
Figure 8. Common types of fasteners for securing
machinery to concrete floors.
Lag Screw
and Anchor
Anchor
Stud
Lag screws and anchors, or anchor studs
(below), are two popular methods for securing
machinery to a concrete floor. We suggest you
research the many options and methods for
securing your machine and choose the best one
for your specific application.