Filter
Top Products
8
Connect the Portable Device
1. Connect the adapter plug into the power jack on the portable device.
2. Turn on the portable device and use it as you would normally.
While connected, myPower ALL Plus
will power and charge your device. (As mentioned earlier, myPower ALL Plus will not charge a device
if the voltage setting is lower than that required.)
or
Leave the portable device turned off and myPower ALL Plus will charge the device battery.
3. When finished, unplug the power output cord from myPower ALL Plus and your device and slide the
voltage right to the unlocked/off position (UNLOCK/OFF) to turn off the USB power when myPower
ALL Plus is not in use.
NOTE: If your portable device displays a low voltage/low capacity or double-beep warning while
myPower ALL Plus is connected, adjust the voltage setting to one level higher
.
TIP: For most portable devices, myPower ALL Plus can be used to power the device even when the
device battery is not installed.
Connect the 5V Device
1. Connect the USB adapter tip (or other optional adapter tip UA-xxx) into the retractable USB cable.
2. Connect the retractable USB cable into the USB port on myPower ALL Plus.
3. Connect the adapter tip into your 5V device.
4. Slide the voltage lock to the lock/on position (LOCK/ON) to turn on the USB port.
While connected,
myPower ALL Plus will power and charge your device.
5. Slide the voltage lock to the unlocked/off position (UNLOCK/OFF) to turn off the USB power when
myPower ALL Plus is not in use.
NOTE: The USB port provides only 5V of power, so the voltage cannot be changed. When using this port,
you will not select the voltage.
MP3450_ug_0507_rev3_r1 6/6/07 10:08 AM Page 8