Filter
Top Products
3
USER GUIDE
Getting to Know myPower ALL Plus
Charging myPower ALL Plus
myPower ALL Plus will charge in four hours when completely empty. The green CHARGE indicator will
turn on after the battery is 80% charged. Therefore, you should view the actual battery capacity before
disconnecting the power adapter to stop charging. (Before using myPower ALL Plus for the first time,
you must charge the device for four hours.)
1. Remove the output cord from the DC OUT jack, if connected.
2. Plug the power adapter into the DC IN jack on the end of myPower ALL Plus.
3. Plug the power adapter into a wall outlet.
The red CHARGE indicator will turn on to indicate the
battery is charging and is less than 80% charged.
4. When the green CHARGE indicator turns on, set the voltage lock to LOCK, and press the voltage
selector to view the battery capacity. If the capacity does not indicate full (green LEDs on), continue to
charge the battery until the battery capacity indicates full.
Voltage Indicators/Capacity Indicators
Voltage
Lock/USB
Power
DC OUT
For connection
to device
DC IN
For connection
to power adapter
Voltage Selector
USB Port for connection
to 5V device
Battery port for connection
to MP3450-10
Charging/USB Indicator
MP3450 MP3450-10
MP3450_ug_0507_rev3_r1 6/6/07 10:08 AM Page 3