Filter
Top Products
7
USER GUIDE
TIP: You can optimize the use of myPower ALL Plus with your notebook computer or portable DVD
player by setting the voltage on myPower ALL Plus to less than the required voltage shown on the
notebook computer power supply. This prevents myPower ALL Plus from charging the device, thus
extending the amount of time you can use myPower ALL Plus to power your notebook computer.
Most notebook computers have a battery voltage of 11.1V or 14.8V, allowing them to be powered with
12V or 14V. Therefore, it is recommended that you set the voltage to 12V first, and then test to see if it
will power your notebook. If not, increase the voltage to 14V, and retest. For MP3400 repeat this process
until you reach the voltage that will power your notebook.
Most portable DVD players require 9 or 12 volts. Set the voltage to 7.5V and test to see if myPower ALL
Plus will power your device at this setting. If not, increase the voltage by one level and retest.
Device Type Voltage on Device Suggested Voltage on
Power Adapter myPower ALL Plus
Notebook Computers
14V 12V
16V 14V
19V 14 - 16V
24V 19V
Portable DVD Players
9V 7.5 - 9V
12V 9 - 12V
Digital Cameras 5 - 6V 5 - 6V
CD Players 4.5 - 5V 5V
PDAs 5V 5V
Mobile Phones 3.7 - 6V 5 - 6V
Digital Camcorders
9V 7.5 - 9V
12V 9 - 12V
MP3/MP4 5V 5V
myPower ALL Plus VOLTAGE SELECTION
This table
provides
recommended
voltage
settings by
device type.
MP3450_ug_0507_rev3_r1 6/6/07 10:08 AM Page 7