Filter
Top Products
Maintenance
6–18
THS710A, THS720A, THS730A & THS720P Service Manual
Contact side of cable
Figure 6–9: Opening the display cable connector
Installation. Use this procedure to install the display module and inverter board.
1. Open the display-cable connector on the back of the display module.
2. Hold the display module upright as shown in Figure 6–8.
3. Insert the display cable into its connector and then use the
1
@
8
inch flat-bladed
screwdriver to close the connector. Check that the display cable is fully
inserted into the connector.
4. Fold the display module back into the chassis and seat it between the foam
pads.
5. Plug the cable from the display module into the inverter board and then route
the cable in the channels as shown in Figure 6–10.
6. Place the inverter board into its cavity over the guideposts in the chassis.
7. Reconnect the connector to the bottom of the inverter board and route the
wires as shown in Figure 6–10.
8. If you just installed a new display module, peel off the protective plastic
sheet.
9. Fold the switch flex-circuit assembly back over the display module and
inverter board.
10. Install the switch mat and front cover using the procedure on page 6–12.