Filter
Top Products
TECHNICAL SPECIFICATIONS:
Model Number ZJ4116QA
Rating Voltage 120 Volts,
60Hz, AC
Chuck Size 5/8”
Net Weight 46.2 Lbs
Number Speeds 9
Spindle Stroke 2”
Spindle Taper MT2
CONTENTS OF PACKAGING
Check all loose parts from the box with the list below. Assemble according to the
instruction on the following pages.
1． Drill press head and motor
2． Column and base flange
3． Base
4． Table
5． Chuck guard
6． Bolts for base and column
7． Chuck
8． Chuck key
9． Operating handles
10. 3mm and 4mm wrench
If any of the above items are missing, please contact our service department at
1-888-367-7373 (http://wwwk.wk-usa.com) for replacement.
WARNING! To prevent accidental starting that could cause possible serious personal
injury, assemble all parts to your drill press before connecting it to power supply.
Drill press should never be connected to power supply when you are assembling
parts, making adjustments, installing or removing drill bit, or when not in use.
z Carefully remove all parts from the carton and place the drill press on a level
work surface. Separate and check against the list of loose parts.
WARNING! If any parts are missing, do not operate this tool until the missing parts
are replaced. Failure to do so could result in serious personal injury.
z Do not discard the packing materials until the drill press has been carefully
inspected, all parts identified, and drill press has been satisfactorily operated.
Note: If any parts are damaged or missing, do not attempt to plug in the power cord
and turn the switch on until the damaged or missing parts are obtained and are
installed correctly.
11