Filter
Top Products
Fastening drill press to supporting
surface
If during operation there is any
tendency for the machine to tip over,
slide or walk on the supporting
surface, the machine base must be
secured to the supporting surface with
bolts, through the two holes (A) Fig.
11, located in the machine base.
Fig. 11
Table adjustments
1. The table can be raised or lowered
on the drill press column by
loosening the table clamp handle
(A) Fig. 12. Move the table to the
desired position on the column and
tighten table clamp handle (A).
Fig. 12
2. The table can be tilted right or left.
Fig. 13
Changing speeds and adjusting
belt tension
A
Note: A belt positioning speed chart
(E) Fig. 14, is located on the inside top
cover of the drill press.
1. Disconnect machine from power
source.
2. Lift up the belt and pulley cover (A)
Fig. 14.
3. Release belt tension by loosening
tension knob (B) Fig. 14, and
pushing the motor (D) toward the
front of the drill press.
4. While holding the motor toward the
front of the drill press, position the
belt (C) on the desired steps of the
motor and spindle pulleys, as
shown in Fig. 14.
A
E
D
A
C
B
Fig. 14
14