Filter
Top Products
ASSEMBLY AND OPERATION
Warning! For your own safety, do
not connect the drill press to the
power source until the machine is
completely assembled and the
entire instruction manual has been
read and understood.
Assembly
1. Assemble the column (A) Fig. 4, to
drill press base (B) as shown, using
the three hex head cap screws (C).
Fig. 4
2. Place the table (D) Fig. 5, on the
drill press column (A) as shown.
Fig. 5
3. Thread stud on clamp handle (E)
Fig. 6, into hole in rear of table
bracket as shown.
Fig. 6
4. Place the drill press head (F), onto
the column (A) as far as it will go.
Align head (A) Fig 7A, to table (B),
and base (C). Tighten the two head
locking screws (G) Fig. 7 with
wrench supplied.
C
A
B
Fig. 7
12