Filter
Top Products
Using vise for clamping the
workpiece
1. Take out the 2-1/2” vice from the
packaging, and put it on the work
table.
2. Use four bolts to fasten the vice on
the work table, and adjust the
position of vice on the work table
at the desired position when
operating.
Adjusting Feeding Depth
1. Mark the depth of the hole on the
side of the workiece.
2. Loosen the depth scale lock screw.
3. With the switch to the off position,
bring the drill bit down until the tip
of the bit is even with the mark on
the side of the workpiece. (Fig 17)
4. Turn the depth scale counter-
clockwise until it stops moving,
5. Tighten the depth scale lock screw.
6. The drill bit will now stop at the
desired depth until the depth scale
is readjusted.
FIG.16
FIG.17
16