Wagner SprayTech 1420 Paint Sprayer User Manual


 
PLUGGING IN THE SPRAYER
1. Check that the ON/OFF
switch is in the OFF
position.
2. Plug the sprayer into a
heavy duty grounded
extension cord. Refer to
Important Electrical
Information, page 3).
P
RESSURE RELIEF PROCEDURE
Be sure to follow the pressure relief procedure (page 6)
when shutting the unit off FOR ANY PURPOSE. This
procedure is used to relieve pressure from the spray hose.
1. Lock the spray gun off.
2. Flip the ON/OFF switch to
the OFF (O) position.
3. Unlock the spray gun,
turn the PRIME/SPRAY
knob to PRIME, and
trigger spray gun into
paint bucket.
4. Lock the spray gun.
PAINT STRAINING
It is recommended that in order to avoid premature tip and gun
plugging you should strain your paint before spraying. Follow
manufacturers recommendations.
SPRAY
PRIME
o
GX-08/10
GX-06/07
WARNING
o
This column contains instructions that will be repeated
throughout this manual.
Customer Service: 800-686-8525 6 © 2002 Wagner Spray Tech - All rights reserved.
CHOOSING THE CORRECT SPRAY GUN FILTER
Use the proper gun filter based on the tip size being used.
B
EFORE YOU PRIME THE SPRAYER
Before priming, squirt a teaspoon of separating oil (P/N 0279920
included with unit) into the indicated area. Light household oil
can be substituted if necessary. Do not put more than a
teaspoon into the lubricating area. Too much oil will leak down
into your paint.
All units are performance-tested at the factory and are shipped
with test fluid in the fluid section to prevent corrosion during
shipment and storage.
Whether you are going to spray latex or oil-based
paints, this fluid must be purged and thoroughly cleaned
out of the system (follow Purging and Priming the Pump
steps, page 7).
If the pump has already been used you will need to purge the
water or solvent used in cleanup and storage.
IF YOUR UNIT HAS ALREADY BEEN USED. . .
IF YOUR UNIT IS NEW. . .
Part No. Tip Size Filter
Type
Mesh
Number
Qty.Color of
Filter
Body
0154918 .011 Extrafine
180 mesh
0.084 mm
red
2 pack
2 pack
2 pack
0154675 .013 - .015 Fine
100 mesh
0.140 mm
yellow
0154842 .017 - .023 Medium
50 mesh
0.315 mm
white
English
BEFORE YOU BEGIN