Filter
Top Products
1
SPECIFICATIONS
GM2000 EAC SPRAYGUN (P/N 0179673)
Air Pressure, max. 145 psi
Material Pressure, max. 3625 psi
Air Volume 10 CFM@ 45 PSI
Material Volume Varies due to Tip size
Air Connector 1/4 inch
Material Connector NPS 1/4
Length 11.8 inches
Height 10 inches
Weight 21 oz.
Input voltage 22 VAC
Input Current, max. 0.8 A
Frequency 26 kHz
High Voltage 80 kV DC
Output Current, max. 100 A AC
Polarity Negative
Cable, Connecting 36 ft.
INTRODUCTION
INTRODUCTION TO ELECTRO-STATIC
SPRAYING
VM200 ELECTROSTATIC POWER PACK
(P/N 0179637)
Length 7.5 inches
Width 4.75 inches
Height 3.5 inches
Weight 3.9 lbs.
Input - VAC 110 - 60 Hz
Power consumption max. 15 W
Output Voltage 80 KV
Output Current max 0.7 A
Output Frequency 17 kHz
Power Cord 9 ft.
The spraying medium is atomized using a pneumatic or
diaphragm pump and a booster air feed supply. A high DC
voltage (up to 80 kV), applied across the grounded compo-
nent and the electrode fitted to the gun body generates an
electric field and applies a negative charge to the paint
particles. These repel each other as they move from gun to
workpiece and so distribute evenly through the fine spray
cloud and then uniformly deposit on the positively grounded
surface. Particles shooting past the component remain
trapped in the electric field and deposit on the backside of
the work object. Effective material yield up to 90%, time
savings up to 80%, markedly improved quality of finish, less
cleaning and a healthier environment are the principal
properties of the process.
FEATURES:
Minimum overspray
Coating by electrostatic wrap-around action
Good atomization of charged particles
ADVANTAGES:
Effective material utilization up to 90%
Enormous time and labor savings
NOTE
Use only coating materials with a specific re-
sistance of 50 - 3.500 K Ohms . If you are not
sure of the specific resistance check with the
coatings supplier before using.
7