Wagner SprayTech 3.31 Paint Sprayer User Manual


  Open as PDF
of 36
 
12 ProSpray3.29•3.31
GB
Spraying technique Handling the high-pressure hose
 






The key to a good paint job is an even coating over the entire
surface.Keepyourarmmovingataconstantspeedandkeep
the spray gun at a constant distance from the surface. The best
spraying distance is 25 to 30 cm between the spray tip and the
surface.
25 - 30 cm
Keepthespraygunatrightanglestothesurface.Thismeans
movingyourentirearmbackandforthratherthanjustexing
your wrist.
Keepthespraygunperpendiculartothesurface,otherwiseone
end of the pattern will be thicker than the other.
Trigger gun after starting the stroke. Release the trigger before
ending the stroke. The spray gun should be moving when the
trigger is pulled and released. Overlap each stroke by about
30%. This will ensure an even coating.
25 - 30 cm25 - 30 cm
i



 
Avoid sharp bending or kinking of the high-pressure hose. The
smallest bending radius amounts to about 20 cm.
Do not drive over the high-pressure hose. Protect against sharp
objects and edges.


immediately.


 
The unit is equipped with a high-pressure hose specially suited
for piston pumps.
i
Only use WAGNER original-high-pressure hoses


 
1. Open the relief valve, valve position PRIME
(k circulation).
2. Switch the unit OFF.
3. Turn the pressure control knob counterclockwise to
minimum pressure.
4. Pull the trigger of the spray gun in order to release the
pressure from the high-pressure hose and spray gun.
5. Secure the spray gun, refer to the operating manual of the
spray gun.
6. If a standard tip is to be cleaned, see Page 19, Section
12.2.
If a non-standard tip is installed, proceed according to the
relevant operating manual.
7. Depending on the model, leave the suction tube or the
suction hose and return hose immersed in the coating
material or swivel or immerse it into a corresponding
cleaning agent.
Attention



time.
 previous next