Filter
Top Products
ProSpray3.29•3.31 17
GB
Repairs at the unit
14. Unscrewlowerhousing(Fig.13,Item10)withadjusting
wrench while holding the upper housing (11) securely with
a second adjusting wrench.
15. Remove bearing ring (13) and O-ring (12).
16. Screw out outlet valve housing (14) from the piston (15)
with 3/8 inch hexagon socket head wrench.
17. Remove the upper seal (16), upper ball guide (17), outlet
valve ball (18), washer (19) and outlet valve seating (20).
18. Clean all the parts with the corresponding cleaning agent.
Check outlet valve housing (14), outlet valve seat (20),
outlet valve ball (18) and upper ball guide (17) for wear
and replace parts if necessary. If the worn outlet valve
seat (20) is unused on one side, install it the other way
around.
19. Carry out installation in the reverse order.
Lubricate O-ring (12) with machine grease and ensure
proper seating in the lower housing (10).
11
15
16
17
18
19
20
14
12
13
10
1. Remove inlet valve housing in accordance with the steps
in Chapter 11.2, Page 16.
2. It is not necessary to remove the outlet valve.
3. Loosen lock nut (Fig. 14, Item 5) counterclockwise with
light blows from a hammer.
4. Unscrewupperhousing(6)counterclockwisefromthe
gear unit housing.
5. Clamp upper housing (6) at the wrench surfaces vertically
in a vice.
Attention
6. Screw out threaded joint (7).
7. Slide the piston rod (4) forward until the piston is out of the
T-slot (2) on the slider assembly (3).
8. Push piston (4) downward out of the upper housing (6).
Check piston for wear and replace if necessary.
9. Remove upper packing (8) and lower packing (9) from the
upper housing (6).
Attention
3
1
2
5
7
10
8
9
6
4
11
10. Remove the transportation devices from the upper and
lower packings. (The transportation device from the upper
packing is required for installation of the piston.)
11. Lubricate upper packing (8) and lower packing (9) with
machine grease.