Filter
Top Products
HAZARD: EXPLOSION HAZARD DUE TO
INCOMPATIBLE MATERIALS
Will cause property damage or severe injury.
PREVENTION:
• Do not use materials containing bleach or
chlorine.
• Do not use halogenated hydrocarbon solvents such as
bleach, mildewcide, methylene chloride and 1,1,1 -
trichloroethane. They are not compatible with aluminum.
• Contact your coating supplier about the compatibility of
material with aluminum.
HAZARD: GENERAL
Can cause severe injury or property damage.
PREVENTION:
• Read all instructions and safety precautions before operating
equipment.
• Follow all appropriate local, state, and national codes
governing ventilation, fire prevention, and operation.
• The United States Government Safety Standards have been
adopted under the Occupational Safety and Health Act
(OSHA). These standards, particularly part 1910 of the
General Standards and part 1926 of the Construction
Standards should be consulted.
• Use only manufacturer authorized parts. User assumes all
risks and liabilities when using parts that do not meet the
minimum specifications and safety requirements of the pump
manufacturer.
• Before each use, check all hoses for cuts, leaks, abrasion
or bulging of cover. Check for damage or movement of
couplings. Immediately replace the hose if any of these
conditions exist. Never repair a paint hose. Replace it with
another grounded high-pressure hose.
• All hoses, swivels, guns, and accessories must be pressure
rated at or above 2800PSI/193 BAR.
• Do not spray outdoors on windy days.
• Wear clothing to keep paint off skin and hair.
I
MPORTANT ELECTRICAL INFORMATION
Use only a 3-wire extension cord that has a 3-blade grounding plug
and a 3-slot receptacle that will accept the plug on the product.
Make sure your extension cord is in good condition. When using
an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a
drop in line voltage resulting in loss of power and overheating. A 14
or 12 gauge cord is recommended. If an extension cord is to be
used outdoors, it must be marked with the suffix W-A after the cord
type designation. For example, a designation of SJTW-A would
indicate that the cord would be appropriate for outdoor use.
• Always disconnect the motor from the power supply and
relieve hose pressure before working on the equipment.
CAUTION
GROUNDING INSTRUCTIONS
This product must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. This product is
equipped with a cord having a grounding wire with an
appropriate grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded in accordance with
all local codes and ordinances.
Improper installation of the grounding plug
can result in a risk of electric shock.
If repair or replacement of the cord or plug is
necessary, do not connect the green grounding wire to either flat
blade terminal. The wire with insulation having a green outer
surface with or without yellow stripes is the grounding wire and
must be connected to the grounding pin.
Check with a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if you are in doubt
as to whether the product is properly grounded. Do not modify
the plug provided. If the plug will not fit the outlet, have the
proper outlet installed by a qualified electrician.
This product is for use on a nominal 120 volt circuit and has a
grounding plug that looks like the plug illustrated below. Make
sure that the product is connected to an outlet having the same
configuration as the plug. No adapter should be used with this
product.
PRODUCT REGISTRATION CARD
Send in your product registration card or register online at
www.wagnerspraytech.com. Proper registration will serve as
proof of purchase in the event your original receipt becomes
misplaced or lost. Returning this card will expedite the
processing of your warranty. Be sure you write your unit’s date
code on the card before sending it. The date code is located
underneath the base of your unit (for example, S087R). The
additional information will also help us to develop new products
that best meet your needs and desires. If you have any
questions or concerns regarding your registration card, please
call our registration card center at 1-303-394-9077.
IF YOU EXPERIENCE PROBLEMS WITH YOUR
SPRAYER AT ANY TIME DURING ASSEMBLY
,
OPERATION OR CLEANUP, PLEASE REFER TO
THE TROUBLESHOOTING
SECTION OF THIS
MANUAL
(PAGE 12), OR CALL CUSTOMER
SERVICE AT
:
1-800-328-8251
Grounded Outlet
Grounding Pin
Cover for grounded outlet box
WARNING
© 2003 Wagner Spray Tech - All rights reserved. 1-800-328-8251 3
English
SAFETY INFORMATION • READ ALL SAFETY
INFORMATION BEFORE OPERATING THE EQUIPMENT