Filter
Top Products
Customer Service: 800-328-8251 4 © 2003 Wagner Spray Tech - All rights reserved.
English
COMPONENTS AND ASSEMBLY
COMPONENTS
• Spray gun with filter
• Spray tip assembly
• 25 foot long, 1/4 inch diameter high pressure hose.
TOOLS NEEDED FOR ASSEMBLY
• Two adjustable wrenches.
• Extension cord (refer to Important Electrical Information
(page 3).
Do not plug in the unit until setup is complete.
WARNING
CONTROLS AND FUNCTIONS
ON/OFF switch.................The ON/OFF switch turns the unit on
and off (O = OFF, l = ON)
Spray Gun ........................The spray gun controls the delivery of
the fluid being pumped.
Spray Hose.......................The spray hose connects the gun to
the pump.
Return Tube.......................Fluid is sent back out through the return
tube to the hopper when priming.
PRIME/SPRAY knob ........The PRIME/SPRAY knob directs fluid
to the spray hose when set to SPRAY,
or the return tube when set to PRIME.
ASSEMBLY
Place the handle over the unit
frame. Insert the bolts and tighten
the wing nuts over the lock washers.
Thread one end of the high pressure
spray hose to the outlet valve.
Tighten with an adjustable wrench.
Attach return tube to hopper.
Thread the other end of the hose to
the spray gun. Hold the gun with
one adjustable wrench, and tighten
the hose nut with the other.
Spray
hose
Rear
handle
Motor
housing
ON/OFF
switch
Inlet valve
tool
PRIME/SPRAY
knob
Hopper lid
Spray tip
assembly
Trigger lock
Trigger
Handle
Inlet filter
(inside of hopper)
Return
tube
Frame
Outlet
valve
Tip
storage
Spray
gun
Hopper
TipTip
guard
SPRAY
PRIME
SPRAY
PRIME
PRIME/SPRAY
knob
PRIME
position
SPRAY
position
= ON
= OFF
ON/OFF Switch
1
2
3