Wolfcraft 6156 Router User Manual


 
32
OPERATION
Connecting a Vacuum
In the fence, a port is provided that will
accept standard 2-1/2" vacuum hose
connections. If plugged into the switch
box, the vacuum will turn ON and OFF
simultaneously with the router.
Using your router/router table
Setting Depth/Height of the Cut
NOTE: Using scrap board that is
smooth and true is recommended for
making this adjustment.
1. At the end of the board, use a soft
pencil to mark line #1. This indicates
the depth of the cut. See Figure 32.
2. Mark line #2, indicating the height of
the cut.
3. Place your board so that it is snuggly
against the face of the fence. The
end with lines #1 and #2 should be
near the bit.
4. Loosen fence clamping knobs
enough so you can move the fence
easily. Move fence and board so that
the board contacts the outer edge of
the router bit at line #1.
5. Tighten fence clamping knobs.
6. Adjust router height so the cutting
edge of the bit contacts line #2.
7. Make sure bit is securely tightened in
router chuck.
When standing in front of
router table, feed work
from right to left.
Make sure router is
unplugged before starting
depth/height adjustments.
WARNING
PENCIL LINE #1 PENCIL LINE #2
CAUTION
Figure 32