Xantrex Technology 20A12V Battery Charger User Manual


 
Onboard Control and Status Display Panel
975-0401-01-01 1–7
Onboard Control and Status Display Panel
This section describes the parts of the onboard control and
status display panel of the Truecharge™ 2 Battery Charger.
To reduce current draw from the connected battery when AC
power is not present, the panel’s LED control and status
lights are automatically turned off and the buttons are
disabled.
However, to temporarily check the status of the connected
battery when AC power is not present, press the Status button
on the optional remote panel.
Important:
To prevent any unintentional changes in the setting,
“press and hold” for three seconds any Select panel button to
advance and pick the right setting.
To set and cancel an equalization program, “press and hold” for
five seconds both the Charger Mode and Battery Temp. Select
panel buttons.
Figure 1-3
Onboard Control and Status Display Panel
2
4
5
6
1
3