Filter
Top Products
Operation
2–14 975-0401-01-01
Transitioning the Truecharge™ 2 Battery
Charger to ON, Standby, or Disabled
There are two ways to turn ON the Truecharge™ 2
Battery Charger:
• Connect the batteries to the charger (i.e., charger is on
standby) then connect AC power at the source. If the
batteries are not fully charged then charging begins
immediately. If the batteries are fully charged then
charging will go to either standby (two-stage) or float
(three-stage).
Or,
• Press
ON/STANDBY on the remote panel while batteries
and AC power are both connected to the charger (from
Standby).
The charger begins to charge the batteries from Standby.
There are two ways to put the Truecharge™ 2 Battery
Charger in Standby (see Warning below):
• Disconnect AC power at the source (i.e., only the
batteries are connected) or
• Press
ON/STANDBY on the remote panel while batteries
and AC power are both connected to the charger (from
ON).
The charger stops charging but continues to monitor the
batteries.
WARNING: Shock hazard
The Truecharge™ 2 Battery Charger contains hazardous voltages
in all modes including Standby. Even when AC power is removed,
if the Truecharge™ 2 Battery Charger is connected to a battery, the
charger will be energized by the battery. The Truecharge™ 2
Battery Charger is de-energized completely only after all AC and
DC sources have been disconnected for five minutes.