Filter
Top Products
– 7 –
1
2
7DK-018
700-115
AE00111
Oil warning light (Red)
When the oil level falls below the lower level, the oil
warning light comes on and then the engine stops auto-
matically. Unless you refill with oil, the engine will not
start again.
TIP
If the engine stalls or does not start, turn the engine
switch to “ON” and then pull the recoil starter. If the oil
warning light flickers for a few seconds, the engine oil is
insufficient. Add oil and restart.
AE00101
CONTROL FUNCTION
AE00121
Engine switch
The engine switch controls the ignition system.
1 7 “ON”
Ignition circuit is switched on.
The engine can be started.
2 5 “STOP”
Ignition circuit is switched off.
The engine will not run.
DC protector
The DC protector turns off 2 automatically when elec-
tric device being connected to the generator is operat-
ing and current above the rated flows. To use this equip-
ment again, turn on the DC protector by pressing its
button to “ON” 1.
1
2
7DK-052
1 “ON”
Direct current is output. (This is the default position.)
2 “OFF”
Direct current is not output.
7DK-9-10 09.1.27 1:46 PM Page 7