C
HAPTER
3:
C
ONFIGURING
THE
V7122
G
ATEWAY
The V7122 gateway is supplied with application software already resident in its flash memory
(with factory default parameters).
Section
Assigning the V7122 Gateway IP Address
describes how to assign IP addresses to
the V7122. Section
Configuring the V7122 Basic Control Protocol Parameters describes how
to set up the V7122 gateway with basic parameters using a standard Web browser (such as
Microsoft
TM
Internet Explorer).
Section Assigning the V7122 Gateway IP Address applies equally to H.323 and
SIP.
Assigning the V7122 Gateway IP Address
The V7122 gateway is composed of one or two identical media gateway modules. These
media gateways are fully independent, each gateway having its own MAC and IP addresses
(
Table 6
shows the default IP addresses of the V7122 gateway). To assign an IP address to
each of the V7122 gateway modules use one of the following methods:
HTTP using a Web browser (see
Assigning an IP Address Using HTTP).
BootP (see
Assigning an IP Address Using BootP).
The embedded Command Line Interface (CLI) accessed using Telnet (see
Assigning an
IP Address Using the CLI).
DHCP (see the V7122 Digital Gateway User Guide).
Table 6 lists the default IP addresses of the V7122 gateway. You can use the Reset button
at any time to restore the V7122 gateway networking parameters to their factory default
values (see
Restoring Networking Parameters to their Initial State).
Table 6 V7122 Gateway Default Networking Parameters
V7122 Gateway Version Default Value
Single module (up to 8 trunks) 10.1.10.10
Double module (up to 16 trunks) 10.1.10.10 (Trunks 1-8) and 10.1.10.11 (Trunks 9-16)
Default subnet mask is 255.255.0.0, default gateway IP address is 0.0.0.0
V7122 Digital Gateway Installation Guide
23
