Chapter 14 Managing the LECS
190 Avaya M770 ATM Switch User’s Guide
If the M770 ATM Switch is looking for a remote LECS then it can be configured to
use a LECS that is advertising one of the following addresses:
• The WKA
• A specific ATM address on the network.
• The address of an elected M770 ATM Switch resilient LECS.
Viewing the Location of the LECS
You can view the current location of the active LECS on the network.
Note: The output display from the following command will depend on the current
location of the active LECS.
To view the location of the LECS, use the lane lecs location
command:
Command:
M15-155s8:/>lane lecs location
• If the switch is using its own simple LECS then the following output will be
displayed.
Output:
There is a local, simple LECS.
It is advertising the ATM Forum Well-Known Address.
Local LECS clients will use the local LECS.
• If the switch is using LECS redundancy and the local resilient LECS is on standby
then the following output will be displayed.
Output:
The local resilient LECS is on standby.
It will advertise
39.84.0F.80.01.BC.61.DF.00.24.24.24.00.24.24.24.24.24.24.30
The elected LECS is at NSAP
39.84.0F.80.01.BC.61.DF.00.A4.A4.A4.00.A4.A4.A4.A4.A4.A4.30
• If the switch is looking for a remote LECS then the following output will be
displayed.
Output:
There is no local LECS.
Local LECS clients will use the LECS at the ATM Forum well-known
address.
• If the switch is looking for a remote elected resilient LECS then the following
output will be displayed.
Output:
There is no local LECS.
Local LECS clients will use the elected resilient LECS.
The elected LECS is at the ATM Forum well-known address.
