Manually configuring TCP/IP parameters from the printer control panel
Use manual configuration to set an IP address, subnet mask, default gateway, syslog server,
and idle timeout.
Setting an IP address
1. Press to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight TCP/IP.
9. Press
to select CONFIG METHOD.
10. Press
to select CONFIG METHOD.
11. Press
to highlight MANUAL.
12. Press
to select MANUAL.
13. Press
to highlight MANUAL SETTINGS .
14. Press
to select MANUAL SETTINGS.
15. Press
to highlight IP ADDRESS.
16. Press
to select IP ADDRESS.
Note The first of four sets of numbers is highlighted. Each set of numbers represents
one byte of information and has a range from 0 to 255.
17. Press the or arrow to increase or decrease the number for the first byte of the
IP address.
Note To cycle through the numbers faster, hold down the arrow button.
18. Press to move to the next set of numbers. (Press to move to the previous set
of numbers.)
19. Repeat steps 16 and 17 until the correct IP address is entered.
20. Press
to save the setting.
21. Press the P
AUSE/RESUME button to return to the Ready state.
Setting the subnet mask
1. Press to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
EN_WW Network configuration 47
