Unpacking and Assembly 1-15
29. Install the five reservoirs.
You may want to wear gloves during this procedure to pro-
tect your hands from pigment ink stains.
◆ Place the reservoir into the wire rack. Match the color or
cleaning solvent label on the reservoir with the corre-
sponding label on the printer.
◆ Remove the packing material from the ink level floats
inside the ink buckets.
◆ Unscrew the plastic seal on the hook-shaped tube
attached to the filter. Discard, or retain for subsequent
use. A small amount of ink may come out of the tube
(ink will be present in the tubes from factory testing).
◆ Connect the hook-shaped tube to the reservoir’s draw
tube, by pressing down until it seats with a click, and
turning the screw-on connector 3/4 to 1 turn. See
Fig. 1-7 below for location.
Note
Do not connect the hook-shaped tube to the air vent.
Doing so will result in no ink being drawn from the
reservoir.
◆ Connect the float sensor cable from the reservoir to the
data port on printer. See Fig. 1-7 below for location.
Fig. 1-7. Installing the reservoirs
