40
Front Fork Springs (Kit Parts)
The kit front fork springs are available for racing.
1) Front Fork Specifications
Items Original
Rebounded damping setting (Upper) 9th (0 ~ -13)
Compression damping setting (Lower) 7th (0 ~ -16)
Fork oil KAYABA KHL 15-10
Fork oil level 91 mm
Oil lock Oil lock piece
Oil seal – – –
Spring length 240.3 mm (muount), 245.3 mm (free)
Spring constant 9.25 N/mm
Spacer length 101 mm
Sub spring stroke 20.5 mm
2) Front Fork Spring
P/No. A × B × C (mm) Number of Wiring Spring Constant
Original 4.8 × 28.7 × 245.3 15 K = 9.25 N/mm
44026-0046 4.8 × 28.7 × 245.3 15.4 K = 9.0 N/mm
44026-0047 4.8 × 28.7 × 245.3 14.6 K = 9.5 N/mm
44026-0048 4.9 × 28.5 × 245.3 15.6 K = 9.75 N/mm
A: Coil Diameter
B: Spring Inside Diameter
C: Spring Free Length
3) Front Fork Spring Replacement
Replace the main spring referring to the Fork Oil Change section of the base Service
Manual.
NOTE
○ Install the kit springs facing the smaller spring end diameter side upward.
Identification Mark
The following ID marks are on the springs.
Spring
ID Mark (Smaller
diameter end side)
44026-0046 (K = 9.0) One slit
44026-0047 (K = 9.5) Two slit
44026-0048 (K = 9.75) Three slit
