5: Commands and Levels
PremierWave XN Command Reference 51
Displays tunnel accept status.
start character <control>
Sets the accept mode start character.
The character may be input as text, control, decimal, or
hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
tcp keep alive <milliseconds>
Enables TCP keep alive for accept mode tunneling and
sets the timer.
<milliseconds> = timer value, in milliseconds.
Stores the current configuration in permanent memory.
arp (config-arp) level commands
add <IP address> <MAC address>
Adds an entry to the ARP table, mapping an IP address to
a MAC address.
<ip address> = IP address to be mapped.
<mac address> = MAC address in colon-separated form.
Exits to the configuration level.
Removes all entries from the ARP cache.
Removes an entry from the ARP cache.
<ip address> = address of the entry being removed.
Displays the ARP cache table.
Displays the last 20 commands entered during the current
CLI session.
Stores the current configuration in permanent memory.
bridge 1 (config-bridge:br0) level commands
bridging mac address <hexadecimal>
Sets the Bridging MAC Address.
Each byte is represented by two adjacent hex digits.
Bytes may run together or be separated by optional punc-
tuation:
123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc
Note that quotes must enclose the value if it contains
Exits to the config level.
Removes the Bridging MAC Address.
Displays the current configuration.
show history
Displays the last 20 commands entered during the current
CLI session.
Stores the current configuration in permanent memory.
choice 1 (config-wlan-choice:wlan0:1) level commands
apply wlan Try out WLAN settings without saving them to Flash.
If the settings do not work, when you reboot the device,
it will still have the original settings.
Exits to the next higher level.
Removes reference to the profile.
profile <text>
Selects a profile.
<text> = name of the profile.
