5: Commands and Levels
PremierWave XN Command Reference 78
Begin session on serial port.
Enters the configure email level.
Enters the filesystem level.
Kills SSH session with index from "show sessions"
Kills Telnet session with index from "show sessions"
Enters the line level.
<line> = number of the line (serial port) to be configured.
Ping destination continuously with 5 second timeout
Ping destination n times with 5 second timeout
ping <host> <count> <timeout>
Ping destination n times with x timeout (in seconds)
Reload factory defaults to permanent storage
Displays the last 20 commands entered during the current
CLI session.
Show interface statistics
Show UDP/TCP state information
Show thread runtime information
Show active Telnet and SSH Sessions
Enters the SSH configuration level.
ssh <optClientUsername> <host>
Begin SSH session on network <host>.
The optClientUserName must match an SSH Client: Us-
ers configuration entry.
Use "" in optClientUserName to prompt for host username
<optClientUsername>
<host>
<port>
Begin SSH session on network <host>:<port>.
The optClientUserName must match an SSH Client: Us-
ers configuration entry.
Use "" in optClientUserName to prompt for host username
and password.
Enters the SSL configuration level.
Begin telnet session on network <host>.
Begin telnet session on network <host>:<port>.
Trace route to destination
trace route <host> <protocol>
Trace route to destination using TCP, ICMP, or UDP
<line>
Enters the tunnel level.
<line> = number of the tunnel line (serial port) to be confi-
Stores the current configuration in permanent memory.
filesystem (filesystem) level commands
Show the contents of a file
Change the current directory to the specified directory
cp <source file> <destination file>
Show contents of a file as a hex dump
Exits to the enable level.
