Troubleshooting
30
■
The functions System On/Auto Power On and Direct
Change do not work for components connected via RI
These functions do not work when Zone 2 is turned on.
■
The display is dark
Make sure that Dimmer function is not working. Press
DIMMER button and change the brightness level of the
display.
■
The following settings can be made for the
composite video inputs
While holding down the input selector button to
configure, press HOME once at a time until "Video ATT:
On" is appeared on the display. To resume the setup,
repeat the above described step until "Video ATT: Off" is
appeared on the display.
This setting is possible for input selectors assigned with
one of the video inputs "VIDEO 1" to "VIDEO 3" in "3.
Composite". If you have a game console connected to
the composite video input, and the picture is not very
clear, you can attenuate the gain.
Video ATT: Off: (default).
Video ATT: On: (Gain is reduced by 2 dB.)
■
If the picture on your TV/monitor connected to the
HDMI output(s) is unstable, try turning the DeepColor
function off.
To turn off the DeepColor function, press STB/DVR and
ON/STANDBY on the AV receiver simultaneously.
While holding down STB/DVR, press ON/STANDBY
repeatedly until "Deep Color:Off" is appeared on the
display. To reactivate the DeepColor function, repeat the
above described step until "Deep Color:On" is appeared
on the display.
The AV receiver contains a microPC for signal processing
and control functions. In very rare situations, severe
interference, noise from an external source, or static
electricity may cause it to lockup. In the unlikely event that
this happens, unplug the power cord from the wall outlet,
wait at least 5 seconds, and then plug it back in.
Onkyo is not responsible for damages (such as CD rental
fees) due to unsuccessful recordings caused by the unit’s
malfunction.
Before you record important data, make sure that the
material will be recorded correctly.
Before disconnecting the power cord from the wall outlet,
set the AV receiver to standby.
